WARNINGS
- The Ranga Horse™ must be fabricated as per these instructions to ensure correct fitting, load paths and OHS requirements are met.
- The strength of the assembled Ranga Horse™ is significantly affected by timber quality as well as assembled height. Must remain within the recommended limits.
- The Ranga Horse™ brackets are designed for a maximum height of 1200mm using MGP10 timber of dimensions 90 x 35mm.
- Maximum Working Load Limit (WLL) ≤ 250[kg] Per Saw Horse SEE NOTE 2.
PLEASE NOTE: RANGA HORSE™ ARE ASSEMBLED UPSIDE DOWN TO ENSURE BRACKETS ARE SQUARE TO TIMBERS FOR LOAD TRANSFER BETWEEN TOP CHORD AND LEGS.
STEP 1
Attach each Ranga Horse™ bracket to top cord timber Max. 900mm apart with 4 TEK screws (per bracket) through holes provided in bracket. Ensure brackets are pushed down firmly and square to top cord timber.
STEP 2
Insert each leg timber into Ranga Horse™ bracket slots, ensuring timber butts firmly onto top cord before securing with a Single TEK screw per leg initially. SEE NOTE 1.
STEP 3
Stand Ranga Horse™ upright and move legs timbers until they have located into a secure position, then install the second TEK screw (per leg) thus fully securing leg timber(s) in position.
STEP 4
Use two Ranga Horse™ sawhorses with a maximum recommended spacing between Ranga Horse™. SEE NOTE 3.
STEP 5
The Ranga Horse™ sawhorses is designed to support electrical cable reels, but recommend shorter legs for stability, screw supporting CHS or Wooden Bar through lower holes with TEK Screws. SEE NOTE 2.
